The battery ran low and would not start the van. I also noticed the leds on the two A/C control buttons flash every second. I replaced the battery and the van starts, but the leds still flash. Dealer said that I would have to pay to reset the BCM. Can someone clue me in to how to reset the BCM myself? Does the flashing leds indicate a problem? How do I determine what was detected?
Thanks
I just noticed a post right before mine had part of the answer. After I ran the cool down test neither led was flashing or lit.
a.. Set Blower motor ON HIGH b.. Set Mode position to Panel c.. Open all A/C outlets d.. Set Temperature to Cold (Both slide pots if equipped) e.. Depress WASH and REAR WIPER button simultaneously for 5 Seconds (Until all LED's light) RESULTS: a.. All LED's will turn on for 5 Seconds b.. Calibration Test is running when REAR WIPER and INTERMITTENT are alternately flashing. Cooldown test is running if A/C and RECIRC are alternately flashing. c.. Acceptable results is REAR WIPER LED is the only LED flashing. Push Rear Wiper to exit. d.. After all tests have passed, Calibration Diagnostics and Cooldown can be run separately. COOLDOWN TEST ENTRY a.. Set Blower motor ON HIGH b.. Set Mode position to Panel c.. Open all A/C outlets d.. Set Temperature to Cold (Both slide pots if equipped) e.. Depress WASH and A/C simultaneously for 5 Seconds NOTE: Prior to start of test, If the evaporator is already cold, the system will fail test. To correct, operate system with A/C OFF and the blower motor ON high for three minutes prior to starting test.
RESULTS: a.. All LED's will turn on for 5 Seconds b.. Cooldown Test is running when A/C and RECIRC. are alternately flashing. If A/C and RECIRC. are flashing simultaneously, Cooldown has failed.
Glenn Beasley Chrysler Tech
MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.