96 intrepid rear drum brakes

What size nut holds on the back brake hub on a

1996 Intrepid? I thought it was a 34mm deep socket but it seems bigger than that. Thanks for any help.
Reply to
den630
Loading thread data ...

According to this thread (has what appears to be the procedure out of the FSM) on DI.net:

formatting link
guy used a 1-7/8" socket, which, if correct, would translate into either a 47 or 48mm. Torque would be 124 ft-lbs. Bill Putney (To reply by e-mail, replace the last letter of the alphabet in my address with the letter 'x')

Reply to
Bill Putney

formatting link
some guy used a 1-7/8" socket, which, if correct, would translate into> either a 47 or 48mm. Torque would be 124 ft-lbs.>

Thanks Bill I didn't even know that there was a

formatting link
web site. There is allot of good information on the site. Thanks again Den

Reply to
den630

formatting link

You're welcome!

Bill Putney (To reply by e-mail, replace the last letter of the alphabet in my address with the letter 'x')

Reply to
Bill Putney

MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.