1. Home
  2. Chrysler Cars
  3. Stratus--leaking left/right wheel cylinders

Stratus--leaking left/right wheel cylinders

I have a question. I recently took my 98 Dodge Stratus with 47,000 miles to the dealer to get it inspected. I was able to get the emissions exempt as it was driven under 5,000 miles in 12 months. I was told that BOTH left and right rear brake wheel cylinders are leaking. My questions are, is it common for them to leak at the same time or does one usually go first? I have no problem replacing them but it just seemed odd that they both are leaking. Would there have been any tell-tale signs of leakage? I appreciate any and all advice.

Thanks! dave no spam--remove last 3 letters in address to respond

Reply to
DSegal1027
Loading thread data ...

Sure, pull off the rear wheels and the brake drum and check for yourself - it isn't hard. Worse case might be the need to screw a bolt into the side of the drums in order to act as a "puller".

Without doing the above you have no way of knowing whether or not they are telling you the truth. Unless the cylinders are leaking very badly, you will never see any fluid from an external inspection. Is it possible that both are leaking? Sure, not common but certainly possible. One may have started to leak undetected last year. The other may have started last week.

Doug

Reply to
sparks065

Brake fluid ever been changed? This helps keep moisture out of the system. Wheel cylinders leak as much from moisture settling in the cylinders and corrosion pitting the cylinder body as from wear.

Bill Putney (to reply by e-mail, replace the last letter of the alphabet in my address with "x")

Reply to
Bill Putney

No, the brake fluid has never been changed. I don't have a problem paying for the repair, it just seemed funny to have both sides leak at the same time. I will say that for a few years (even after getting new brakes), there was always brake squeal in the mornings when first driving the car. It went away after hitting the brakes a few times. I notice that there has been no squealing as yet...not sure if this is related.

thanks for the advice. no spam--remove last 3 letters in address to respond

Reply to
DSegal1027

Whenever I've had to do this job I've just replaced both cylinders. The telltale is usually discoloration on the outside of the cylinder, like a stain, spreading from the end. It should be bone-dry in there, and very dusty.

This is a job that can rapidly turn into an expensive one because almost always when a shop pulls the brakes apart they are going to suggest changing friction material, drums/rotors etc. You have some time and you should shop around, lots of places do brake jobs.

Ted

Reply to
Ted Mittelstaedt

Wow - that's what I call jumping to conclusions. Why would you assume something like that!!??

Bill Putney (to reply by e-mail, replace the last letter of the alphabet in my address with "x")

Reply to
Bill Putney

MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.