Explorer check gage light and oil pressure not reading

Hey everyone,

My 99 Ford Explorer with 81,000 miles has a problem. When from a cold start, my check gage light may come on and no oil pressure shows. Than the oil pressure needle bounces a couple times and reads normal. Or I turn the engine off and back on and than it reads. It has oil changes every 3k miles and only other problem was a M.A.F sensor was replaced. No codes yet to provide, but will get them and post them up. This does not happen all the time, but the times it does happen has been from a cold start in the mornings. Started about two weeks ago and has happened maybe three times. Temps outside have varied from mid 30s to single digits on the mornings it has happened.

Thanks, Lance

Reply to
Lance
Loading thread data ...

Reply to
Big Shoe

My '01 did this and it was a bad sending unit. Dealer said there was a TSB on this.

Reply to
Ed Mann

MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.