I have a F250, 1990, 351, auto. If I turn the ignition switch to RUN the start relay clicks but the starter motor doesn't run at all. The battery is new and I replaced the start relay - still the same problem. Voltage at the battery terminal of the start relay is 12.7; when turning the ignition switch to RUN there is no voltage at the M- terminal of the start relay. Any idea??
Thanks in advance Wilf
On Wed, 30 May 2007 20:51:25 -0700, rfswlbc rearranged some electrons to form:
Bad starter. Loose/bad ground cable from engine block Loose/bad cable from starter relay to starter
What is the voltage on the *starter* terminal of the relay when you trun the ignition switch? (that's the BIG one that goes to the starter)
Maybe the neutral/park switch?
>Dirty battery terminal clamps?
Thanks guys,
problem solved. The cable between battery and relay was broken
MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.