1. Home
  2. General Motors Forum
  3. 2000 venture

2000 venture

Can any one help me program new key fobs for keyless entry.. thank you

Reply to
audvidal
Loading thread data ...

Perform the following steps in order to program the transmitter:

1.. Remove the ignition key from the ignition lock cylinder. 2.. Remove the BCM PRGRM fuse from the fuse panel. Refer to Fuse Block in Wiring Systems. 3.. Close all of the doors. 4.. Close the liftgate. 5.. Turn the ignition lock cylinder to ACC. 6.. Turn the ignition lock cylinder to OFF, and then back to ACC within 1 second. 7.. Open and close any vehicle door. A chime will be heard when the system enters the BCM programming/diagnostic mode.

Important After 7 seconds, a chime may be heard confirming successful synchronization. It is necessary to wait approximately 14 seconds for a second chime that will confirm successful programming.

8.. Press and hold the transmitter LOCK and UNLOCK buttons simultaneously for 14 seconds. 9.. Repeat the previous step on each additional transmitter to be programmed. 10.. Remove the ignition key from the ignition lock cylinder. 11.. Install the BCM PRGRM fuse back into the fuse panel. Refer to Fuse Block in Wiring Systems.

Ian

Reply to
shiden_kai

MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.