2001 malibu keyless entry programming

2001 Malibu LS

Anybody know how to program a new transmitter to lock and unlock doors?

Denis

Reply to
D. Gignac
Loading thread data ...

With either RKE module you need a scan tool!

RKE Module Integrated Into the BCM

Important Up to 4 transmitters can be programmed. Do not operate or program the transmitters in the vicinity of other vehicles that are in the keyless entry program mode. This prevents the programming of the transmitters to the incorrect vehicle. The order in which the transmitters are programmed is important. The first transmitter programmed will be transmitter #1 and the second transmitter programmed will be transmitter #2 and so on. Use care to program the transmitters correctly.

1.. Install a scan tool. 2.. Turn ON the ignition with the engine OFF. 3.. Have all the transmitters available that you want to program. 4.. In order to add or replace a transmitter, use the scan tool Body Control Module (BCM) Special Functions: Add/Replace key FOB in order to place the BCM into program mode. 5.. In order to program all of the transmitters, use the scan tool BCM Special Functions: Clear Memory/Program all Fobs in order to place the BCM into program mode. 6.. The BCM will confirm entry into the program mode by sounding the chime twice.

Important The scan tool must stay connected until all of the transmitters are programmed.

7.. Press and hold the LOCK and the UNLOCK buttons simultaneously on one transmitter for approximately 12 seconds. The BCM will confirm the programming of that transmitter by sounding the chime twice. 8.. If you are programming additional transmitters, repeat the previous step to program up to four transmitters. 9.. Remove the scan tool. 10.. Exit the vehicle. Attempt to lock/unlock the doors to verify the programming of all transmitters. 11.. Operate all the transmitter functions on all of the programmed transmitters to verify correct system operation. RKE External Module

Important All transmitters must be programmed each time any one transmitter is programmed.

The scan tool must stay connected until all of the transmitters are programmed.

1.. Install a scan tool. 2.. Turn ON the ignition with the engine OFF. 3.. Select BODY. 4.. Select REMOTE FUNCTION ACTUATION. 5.. Select SPECIAL FUNCTIONS. 6.. Select PROGRAM KEY FOBS. 7.. Select the number of transmitters to be programmed. 8.. Have all the transmitters available that you want to program. 9.. The transmitters can be identified by a 1 or 2 on the back side of the transmitter. 10.. Press and hold the LOCK and the UNLOCK buttons simultaneously on the #1 transmitter for approximately 15 seconds. The power locks should cycle to confirm programming of the fob is complete. 11.. If you are programming additional transmitters, repeat the previous step to program up to four transmitters. 12.. Remove the scan tool. 13.. Exit the vehicle. Attempt to lock/unlock the doors to verify the programming of all transmitters.
Reply to
Johnoz19

Denis Here try this whats on this web page should work....Let me know how it went Cheers

Reply to
Iron

lol..I guess it would help you if I had pasted the address

formatting link

Reply to
Iron

MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.