Probably.. here's the procedure for this vehicle:
-Once entering this procedure, programming the first transmitter erases all
previous transmitters. You must program all transmitters.
-Program one vehicle at a time. One transmitter could be programmed into
other vehicles that are also on program mode in close proximity.
Sit in the driver's seat.
Remove the ignition key from the ignition lock cylinder.
Close all vehicle doors.
Press and hold unlock on the door lock switch.
While holding the door lock switch in the unlock position, insert and remove
the ignition key twice. Do not rotate the ignition lock cylinder.
Insert the ignition key a third time leaving the key in the ignition lock
cylinder. The ignition must remain in the LOCK position for the rest ofthe
Release the door lock switch. You will hear three chimes. This chime
feedback indicates that transmitter programming is active.
Press and hold the lock and unlock buttons at the same time on the keyless
entry transmitter for 12 seconds. You will hear two chimes. This chime
feedback indicates that the transmitter has been programmed successfully.
Repeat for the rest of the transmitters (for a total of 4 transmitters).
Exit this procedure by removing the ignition key from the ignition lock
Robert Hancock Saskatoon, SK, Canada
To email, remove "nospam" from firstname.lastname@example.org
Click to see the full signature.