1992 Elantra Power Steering pump pressure switch??

On the schematic diagram, one can see that the state of the 1992 Elantra Power Steering pump pressure switch is read by the Engine Control Unit (ECU).

What does the ECU do with this signal? There is no Check Engine Light in this car.

Thank you very much.

Reply to
Jean Castonguay
Loading thread data ...

The ECM uses the signal at idle to bump up the idle actuator a little bit once it sees pressure.

-- Message posted using

formatting link
information at
formatting link

Reply to
hyundaitech

MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.