Maybe I did something wrong but I highly doubt it... You be the judge.
I had a shimmy at 45 MPH which would go away at 50-55 MPH. I tracked it down to the panhard rod being loose at the frame connection. I opted for an Old Man Emu panhard rod poly set for a '96, Discovery, 4.0L.
Took the old ones out and installed the poly bushings onto the rod. No sweat. When installing the rod back onto the vehicle the bushings were tight going in. I placed a small amount of lube supplied in the kit to the outside faces of the bushings to ease them into position.
The LR seemed to drive fine for the first 25 miles. I took the LR to 65 MPH and experienced no trouble. This is where my woes begin...
Whilst slowing down at an intersection the LR started shimming all over the place. I made a left turn drove for 1 mile and made a right turn. Now I could not keep the vehicle on the road. I pulled off to the side an inspected the undercarriage. To my chagrin, the "new and improved" poly bushings disintegrated at both the axle and the frame. Lucky for me I was able to crawl to my destination 1 mile further where it has sat since.
I just order LR bushings.
I have installed OME HD Springs and Dampers all around and this is my first poor experience with OME.
Any suggestions as to why OME's bushings fell apart? I am not too happy with them.