1. Home
  2. Land Rover 4WD vehicles
  3. Series III restoration 2

Series III restoration 2

I have been think about the future of my Series 3 109 (Sandy) I did a restoration about 6 years ago and got Sandy to a good standard. Six years of use & about and a little neglect and its time to look at another refresh to get her though the next 5-10 years. Sadly this time round I don't have the time to do the restoration myself and wanted to see if anybody could recommend somebody to do a restoration. I am looking for either a full chassis up rebuild or effectively a custom build using my series III as a donor. Does anyone have any suggestions?

Reply to
Martin
Loading thread data ...

You couldn't have done much of a restoration if it's only lasted 6 years. :-)

Martin

Reply to
Oily

Your probably right (I did do most of the wotk myself), although I have seen vehicles in much worse condition described as being in A1 etc. I'm sure it will last another 10 years without major problems. Its just a question of standards. New doors, dash top and a re-spray would make it a very good example again. But I want near concourse and possibly a new v8 installing which is beyond me in time and complexity.

Reply to
Martin

MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.