Here are a few of my electrical problems on my week old Cosworth '95 (LHD) I hope you may be able to recognise some of them and be of help.
On the drivers side door, 3 window switches work but the one for the passenger door window. How to fix?
Drivers window goes down-up only while switch is held. Is that normal behaviour?
Or should it have one-touch?
Passenger door window switch works; window going up and down while switch is held. Is that normal behaviour? Or should it have one-touch?
Rear windows both go down in one-touch; up only while switch is held. Is that normal behaviour?
Remote control does not work, nor for doors, nor for the boot, nor for alarm. Batteries new. Where is the receiver? Can I test this?
When driver door/or passenger door is locked using key, all 4 doors double-lock, alarm light comes on, and after 5 secs some windows close (when open)
When driver door/passenger door is un-locked using key, all 4 doors un-lock, after 5 secs rear windows open (when closed).
I understand alarm, locking and windows is controlled just by 2 wires and by the CCM, correct? So would regular voltage & wire testing work, or not?
Can I do any checks, tests e.g. replace switches to localise and fix the problems?
I have not yet reset the EEC-V by disconnecting the battery; would that be of any help?
Curious, Maria
PS My earlier Cosworth was a '98; this one '95 may be different