Help 1984 500 sel

Hi all, Have a prob with my "new" 500 sel. Its a 1984 and had been sitting awhile, it runs good but has a poor idle doesn't smooth out till about 800 rpm, and it also has been blowing black smoke, altho I didn't burn a drop of oil from ny to tx. I think the gas may be too rich, and I need a vacuum diagram for the breather and valve vacuum lines. I am missing a line on the cold start valve, and I think oil is coming out of somewhere and going down the injector throttle via the breather . any and all help appreciated , oil pressure is 4 bars, down to about 2 when it is at 500 rpm's. Thanks ahead, Jim

Reply to
<benz831
Loading thread data ...

Hi all, I worked on the car a little more today , so can add a little info. The only way I can get the car to run is to pull the vaccum line off the intake manifold where it goes to the cold start valve and also the little dashpod like valve in the corner there , I am not sure what that is called. It is still blowing black carbon out and I pulled and am changing the plugs and they are all carboned up. The vacuum line on the manifold must have been disconnected all along, or I don't think I could have driven it all the way here from jersey as it runs so bad with it off. Thanks, Jim

Reply to
<benz831

Do yourself a favor and get a factory service manual on CD off ebay. You will need alot of info.

That device you are referring to is called warm up regulator. It also act like fuel enrichment for full throttle condition.

Cold start valve is on the driver side in the front that lone injector up in the air with one wire harness on it.

Reply to
Tiger

MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.