I have recently installed the C&L 73mm with pipe, and a Professional Products 65mm Throttle Body and spacer. I adjusted the throttle position sensor according to their instructions and did all else as instructed.
Here is the problem. I am constantly fighting the idle adjustment and the TV cable adjustment to reach a happy medium.
They can't seem to get along. When the TV cable is adjusted for proper shifts, it holds the idle up at 2000 in neutral and a little over 1000 in Drive and is almost power braking the car by itself. If I back it off, then the idle is OK, but the shifting is terribly slow and weak.
The TV cable adjustment was performed according to the Haynes manual where you hold the throttle hard against the stop and adjust the plastic slider to the appropriate position before locking it in. It seems to be readjusting itself when driven.
Any help on this would be appreciated.
Thanks.