rear brake pressure regulator on 405 estate

I need a spring for a rear brake pressure regulator for 405 estate (m reg). (with abs if that makes a difference)

I just want the spring not the whole unit as the nice man from peugeot says it =A373 +vat

I have been reliably informed that there is a comparable spring on a citroen but no idea which one. And id be happy for one of those too.

does anyone know where i can get a new one cheap??? i dont fancy climbing round the scrapy in this weather.

cheers si

Reply to
caveman_si
Loading thread data ...

I just want the spring not the whole unit as the nice man from peugeot says it £73 +vat

I have been reliably informed that there is a comparable spring on a citroen but no idea which one. And id be happy for one of those too.

The 405 shares it's floorpan with the BX, but that doesn't have a rear regulator, using it's hydraulic, (olio-pneumatic?) rear suspension pressure to do the same job.

I'd cruise the scrap-yards looking for one on a 405 estate, as the saloon may have a different loading.

-- R

Reply to
R

They were only fitted to estates. ABS made no difference. I had the same problem on my old 405 a couple of years ago. Went to the scrappy and got one for nothing--so to speak!!

Reply to
Nigel

cheers guys just didnt fancy the day at the scrappy but looks like its only way.

ON another note does anyone know what the rear brake pressure regulator actually does? To me it looks like it connects the suspension to the abs braking system but no idea why?

cheers simon

Reply to
caveman_si

The rear brake pressure regulator is there to adjust the amount of braking effort applied to the rear brakes depending on the load the vehicle is carrying. The purpose of the spring is to apply the force to move the regulator valve. Once the valve has moved further movement of the suspension could cause the link to snap if it was just a rod hence a spring. You can use any spring that is the length to just be in tension between the unit and the suspension under no load and of the same gauge. It is possible to braze a piece of wire on the replace the broken part of the spring. This is usually the hook at the suspension end. You could try going to your friendly Peugeot spares dealer and asking to measure the spring. I guess this is not possible as most parts for Peugeots seem to be special order these days. The 406 is also fitted with a similar device.

Mike

Reply to
MICHAEL ROCHE

Hi

What is basicly does is control the amount of braking force to the rear wheels depending on the load on the rear suspension.

If the boot is empty then the rear of the car will be lighter & the rear wheels will be more prone to locking, When the suspension at the rear rises because the front has dropped as the brakes are slammed on the valve reduces the flow of brake fluid to the rear & helps stop the wheels locking up.

If the boot is loaded up with stuff then the rear of the car will be lower, The valve will now let more fluid flow to the rear wheels because theres more weight over the back wheels & theres less chance of them locking.

Hope that helps explain things clearer.

Reply to
Lee Power via CarKB.com

It has nothing to do with the ABS as such. It regulates the amount of pressure needed to work the back brakes in accordance with the amount of load in the back of the car. The more load in the back the more "power" to the rear brakes.

Reply to
Nigel

MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.