Identifying Bad Engine Mounts

What's the best way to test engine mounts on a 900 SE? If I apply the parking brake, put it in first and let the clutch out the front of the engine either raises about an inch, or the rear of the engine lowers an inch. Just wondering if the mounts had to let go completely before they could be identified as bad. Thanks, Ron

Reply to
Ron
Loading thread data ...

You can often see cracks in them. General opinion is that the engine should not move more than 1/2" under torque. Start with the driver's side tranny mount. You will need to remove or loosen the inner fender cover to get a good look at it without having the car on a lift.

Reply to
- Bob -

MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.