Is it possible to replace a lamp that has failed in the switch for the driver's heated seat in a 9-5 Griffin without removing the dash?
Ray
Is it possible to replace a lamp that has failed in the switch for the driver's heated seat in a 9-5 Griffin without removing the dash?
Ray
The switches pop out of the dash. Once you have the switch removed, bulb replacement is obvious. If you disconnect the switch, be careful that the harness does not fall into the dash.
Thanks Brian
I know it may be obvious but how do you get the switch to "pop out" of the dash. Do you prise it out or is there a way of pushing it out from behind?
pry it out with a screwdriver, basically you are only using enough force to dislodge 4 or 5 spade connector male ends on the back of the switch.
Thank you both very much. Successfully replaced bulb. Ray
where do you get the bulbs???
Model number would be sufficient
TIA
dave
where do you get the bulbs???
Model number would be sufficient
TIA
dave
MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.