1. Home
  2. SAAB Cars Forum
  3. Saab 900 classic brake light switch

Saab 900 classic brake light switch

My son has a '89 Saab 900. Early this year I replaced the brake light switch. The faulty switch was sometimes sticking ON causing the battery to run down when parked. The replacement was a new switch from eeuroparts.com.

Now months later, my son reported that the brake light was permanently on while parked and he had to pull the 15A fuse to extinguish the brake lights.

While trouble shooting this, I found the brake light switch to be quite warm to the touch while in the rest position. I checked it with an ohm meter and found 0 ohms when closed, and 100 ohms when supposedly open. With the switch removed from the circuit, I found I could correctly activate the brake lights with a jumper. An ammeter shows the brake circuit drew 7-8 amps when activated. This seemed reasonable since the circuit is fused for 15.

So it appears that this relatively new brake light switch is faulty and is acting as a resistor rather than a switch. So I'm inclined to replace it with another new one. But I have this nagging feeling that perhaps there may be something wrong that caused the failure of the switch.

So am I overly concerned? Should I just replace the switch with another new one and not worry about it? Or is there some other possibility that I need to consider?

Thanks,

jim

Reply to
James Rosenkranz
Loading thread data ...

in article IDaRg.28806$ snipped-for-privacy@bignews8.bellsouth.net, James Rosenkranz at snipped-for-privacy@bellsouth.net wrote on 23/09/2006 14:27:

...

It's hard to say ... When my switch failed, due to the plastic fatiguing, I just glued it in place and it's been fine since. Try another switch and if it's significantly cooler, then the old one was a dud and good job it broke, eh? If it's as warm, then it's probably normal.

I wouldn't worry.

Paul

1989 900 Turbo S
formatting link
Reply to
Paul Halliday

Part may still be under warranty I would call eparts and they may send you out a replacementgood luck papa

Reply to
PAPAGENE4JACK

If this were a Ford product, I'd be concerned about another "better idea" that's gone astray.

It seems quite unlikely that two switches would both fail in short order unless there's something external causing a problem. On the other hand, switches don't casually fail -- they either keep working or fail catastrophically (smoke, flames, molten metal, flying pieces,...).

The 100 ohm "open" reading is quite puzzling. It seems as if something inside the switch housing has melted and is bridging the circuitry, but it's hard to guess what has happened without opening the switch package. And it's hard to imagine what there is within a mechanical switch that can melt...

I'd be inclined to get another switch and advise the seller that the new switch is a replacement for an earlier one that failed shortly after purchase. This wouldn't be a warranty claim but it would create a record of the incident in case another fails in a similar fashion. Reporting the failure might get a response from the seller of a known defect either in the switches or an external cause of the failures.

Reply to
Everett M. Greene

MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.