Automatic Transmission weird shifting
1990 Ford Ranger 4X2 Super Cab V 4.0L A4LD TransmissionMy vacuum modulator failed, automatic transmission fluid was being sucked into the intake. The part has been bad for a good while about a year. I discovered it as my fluid level has been slowly dropping over the last year. The truck ran fine.
I purchase the part, Niehoff # TM115 fits 1987 - 1990 Ranger, when I ordered the part, there were two to choose from; Niehoff also had a TM332 which was for 1983- 1996 Ranger. Not sure what the differences are, altitude?
When I went to replace it things were tight with the cat so I took it to a transmission shop gave them the part and they installed it. The also changed the few inches of vacuum hose at each end of the hard-line as they were full of transmission fluid.
As I drove away from the shop I noticed that at 15 mph it would shift into
2nd (which is normal), then at about 22mph the rpms would go up a good bit, was it shifting back to 1st? Then after 1-2 seconds it would shift back into 2nd. Then as I would pick up speed it would go into third. This was Sat and the shop closed as I left, so I couldn't go back.It repeats this pattern every time, I drove around all day and it would do it every time. If I took off and kept my foot into the throttle a bit it would not happen. It happens if just drive easy.
The truck never did this before. At first I thought that I was getting use to normal shifting since the vacuum modulator was replaced, but the more I drove it I know that this rpm increase, slipping sensation was not normal.
So what could be wrong? Did I put in the wrong part? Is the new part bad? Is there an adjustment involved?
And I did check to see that my transmission fluid is at the correct level.