Gen Ligh Oil Light questions

I installed a new alternator with an internal regulator on my SB 74 i had the old type of alternator with the socket D+ and external regulator i think its a motorola regulator.. so i cut the red wire from the socket and connected it to D+ on the new ALT and connected the B+ battery cable to B+ on the ALT. I then disconnected the external regulator and saw two spliced wired ( Red Green?) i think. I stopped there and didnt know what to do next. I started the car and the gen light came on when i turned the key but when it started the gen light came off as it should, but the oil light didnt turn on while turning the key, Is this normal????? or should the oil light come on as well while turning on the car? I can upload pictures if anyone think it is necessary.

THANKS A MILLION

*Chris
Reply to
ChristianCuriel
Loading thread data ...

You're close on the wiring. Go to my web site and look for: "Wiring diagram for Type I cars with alternator."

The skinny Red wire on D+ should be spliced to the Blue wire which is part of the Main harness. This is under the back seat where the old regulator was. That's the circuit for the "GEN" light in the speedo.

Your other question: yes, the OIL light should come on when the key is turned but before the engine starts up.

The wire for the Oil light is Blu/Grn. Try grounding that wire at the Oil pressure sender (left side of engine) and see if the Oil light comes on.

Make sure the Blu wire didn't get confused with the Blu/Grn somewhere.

Speedy Jim

formatting link

Reply to
Speedy Jim

SUCCESS!! thanks now it is all hooked up correctly !! thanks speedy jim!!!

-Christian

Speedy Jim wrote:

stopped

turning

Reply to
ChristianCuriel

MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.