revving engine--kills engine???

Went on a short trip today about 10 miles round trip. Everything was fine until about a mile an a half from the house. Had to shift down a gear and when I let out the clutch and gave it gas I had big puff of smoke come out from under the engine I was told by a friend. Every time I would give gas the engine would start to die and I would have to push the clutch in to rev up the engine to get it to move. Also it would die on me if I tried to keep going at a constant speed if that makes since.

Any ideas what is the problem could be? Could it be the carb or dist. I just don't want to hear that it is time to rebuild engine?

Its the 72

Reply to
Bill Baker
Loading thread data ...

I had to do the dime thing myself. Had to grind it down a bit, as I recall.

Reply to
Edward Deerly

Reply to
Bill Baker

This little plug thing is a pain in the neck. But, it can be temporarily plugged with just about anything. I have a fishing bobber cork in ours right now. It's been there for a few months. I will have to grind down a dime and fix it soon. I have used, in a pinch, a marble, held in place with chewing gum, to get us home. I think, though, that the carburetor people could fasten that plug in a little better.

Reply to
Russell Funk

just went out to the bug to see if i missed anything yesterday, every thing looks fine. Started it, ran fine, went on a short trip to get engine warmed up and the problems isn't there at the moment.

Any Ideas??

Bill Baker wrote:

Reply to
Bill Baker

Guessing (from the fact that today it worked fine):

  • not getting enough fuel because tank ventilation is not working and eventually the fuel pump cannot get enough fuel out of the tank anymore. When it starts to act up, open the gas tank cap listen if you can hear the underpressure dropping and see if that has any affect in the problem

  • ignition coil going bad and not working when hot

Reply to
Olli Lammi

Is your electric choke hooked up with a good wire?

Reply to
MN AirHead

MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.