Just revived a 164. Added some gas, couple of cranking later the baby just started right up! been sitting in the barn for 4 years ... Drived around a little, the transmission shift OK (4 speed Plus OD.)
Now eager to get her on the road. Need to fix the brakes. The two front brakes are both seized---when jacking up the front wheels, I hadn't been able to turn the wheel by hands. While driving, can barely push it above
40MPH and both front wheel turned hot to the touch. And brake pedal is almost rock solid firm.I had the factory manual and had read about this on the net. My plan is replace the brake hoses and rebuild the calipers. But I do have some questions about how to unmount the calipers since the pistons are solid against the pads and the pads against the disks, and assuming the piston are frozen in place ( a very likely situation), How do I take out the pads without retracting pistons? Brute force? Is there a better way? Or maybe it is easy to dismount the calipers in situations like this. I dont know. I am just trying to go through the whole procedure in my head first, in case there is surprize ahead.
Also about the rebuild kit, which brand is the best? What about Volvo kit? Are they worth it. These are ATE calipers.
Are there any silicone braided fornt brake hoses?
Frankly I've nevr done this job before, only had replaced pads on some TOYOTAs ( floating calipers.) My plan is to leave the calipers connetd to the brake system so I can push the pistons free but not completely out using brake pedal pressure once the calipers are freed from the hub/disks.
Any suggestion from the group will be appreciated.
Also since this is 30-year old car, although not much rust on it, the brake hose/line connections probably are hard to free, PB blaster a week before would do it? I have some impact tools, dont if it is useful or not. Also got some visegrip and hose wrenches. Just dont want to ruin the brake lines.
Bruce
Remove uu to reply