Hi! I've found that ignition in my car is broken. It's on this photo:
This broken can give some symptoms in engine's working?? Something can be bad because of this??
Hi! I've found that ignition in my car is broken. It's on this photo:
This broken can give some symptoms in engine's working?? Something can be bad because of this??
That's a supplemental ground strap. Protects the throttle and kickdown cables from melting during start up if the main ground cable from the battery fails.
Bob
My Friend I writing about the ignition distributor - it's broken!!! Look for the photo ones again!
You have posted the wrong photo.
It does NOT show the distributor.
Uzytkownik napisal w wiadomosci news: snipped-for-privacy@g10g2000cwb.googlegroups.com...
I mark this !! please see again!
I mark this !! please see again!
Ah, now I see it.
The cracks.
Uzytkownik napisal w wiadomosci news: snipped-for-privacy@j33g2000cwa.googlegroups.com...
Yeah:)) but what do You think about it?? Engine can works bad because of it??
I do not think it would make a lot of difference in the engine's performance.
The plate is used to mount the distributor cap to the head: an interface, really, which can be adjusted to change the timing.
So long as you have enough of it intact to tighten the cap at the position you want, and keep it there, it should be OK.
I'm a little concerned that the crack may spread, causing part of the distributor baseplate to fall away. All things considered, even though it may be working okay now I think it would be good to get a replacement from a dismantler.
That distributor is really difficult to get back together right. Getting the rotor to line up is a devil's choice: either set the distributor in place with the cap off so the rotor can be turned by hand, or try to get it to line up with the cap on so the bushing that holds the sensor wire is held in place. I would not be surprised if that's how it came to be broken.
Mike
Whereabouts on the engine is the break, Jarek? A larger area in the picture might make it more identifiable.
All the best, Peter.
700/900/90 Register Keeper, Volvo Owners Club (UK).
If I'm seeing the picture correctly, it is the end of the distributor base plate (B230 engine with the distributor on the tail of the cam shaft) that is broken, right above the mounting hole on the starboard side of the engine.
Mike
U¿ytkownik "Michael Pardee" :
Yes, You are right. I must buy a new distributor? or this broken can't give any problems with engine's working??
what sensor give the signal to EZK to accelerate the ignition when driving?? If I good known, the EZK117 in B230F hasn't got the underpressure sensor from intake mainfold. I know that knock sensor is only to put down the ignition when it's to high.
This module over the pedals is EZK or ECU?? Where I can found the ECU module? The ECU is connected with EZK or it's only for fuel system??
MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.