1995 Passat GLX - Rear rotors and ABS

Hello all,

After some 90K miles I decided to change my rotors, back and front.

Not such a big of a deal... except for one question that worries me...

I remove the ABS ring from the old rear rotors and put them on the new ones. Taking it off was fairly easy. I took a brush, cleaned it and once on the new rotor, the ring was loose as opposed to nicely and firmly stuck on the old rotor.

My question is simple... is this normal that the ABS ring on the new rotor be running freely if I make it spin with my fingers or should I replace it?

Thanks in advance,

Richard

Reply to
Richard Soubyran
Loading thread data ...

Mine were not loose. I would compress things a little so it was a bit snug. I expect crud build-up to make it more fixed over time.

Reply to
Tom's VR6

MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.