Do It Yourself Laser Wheel Alignment

CAUTION

THE FOLLOWING could REALLY F*CK UP YOUR TIRES.

That being said. It could also save you a bundle.

I found a way to align my wheels using a $10 laser level and not much more.

First thing you have to do is zero (calibrate) the laser level so that the laser beam is projected parallel to a theoretical flat surface it rests upon. The way I did this is probably not the best. But it was quick and dirty and seemed like it worked. I placed the laser level's flat surface (mine has magnets there) on a cdrom disk. That's right, a CD. Then I took this arrangment outside at dusk and set it on a wall and compared where the laser beam went to the flat plane of the CD disc it rested on. It was way low so I shimmed the rear of the laser level until the beam and the sightline along the flat surface of the CD were aligned. Then I taped the laser level to the top of the CD and reevaluated the state of alignment. They were still aligned.

Then I placed the flat of the CD disc with the laser level taped to the top of it against flat of the front wheel hub center opening and propped it in place by leaning a 2 foot 4x4 against it. I marked where the laser beam fell at 3 distances from 2 to 50 feet out in front of the car. Then I measured these distances. The difference between the close-in measurements and the farther ones give you the alignment since alignment varying from parallel will be magnified by distance. From there I readjusted the steering arms until the distances close in and farthest out were just a hair toed-in.

This is essentially what an alignment shop does when they adjust your toe-in. A major difference though is they're trainied and have the experience and thousands of dollars of specialized equipment. There are also other variables other than toe-in that come into the picture that an alignment shop can handle that I know I can't (or don't want to go through the trouble). And any time you lay wrench on a suspension or brake or steering component, you are taking the life of yourself and everyone driving around you into your hands. I know all this.

But if you're short of bread and just need to adjust toe in like me after an accident, this can work if you're careful about it. Of course, if your alignment seems OK, your tires arne't wearing fast, then by all means, leave the thing alone.

Reply to
insufferable bore
Loading thread data ...

Minardi racing use this method.............

Reply to
Juan Hunglow

Do you have some pictures of it? I really like the idea.

SFC

"insufferable bore" schreef in bericht news: snipped-for-privacy@4ax.com...

Reply to
SFC

Here are some photos of the cheap and dirty wheel aligner.

formatting link
Do you have some pictures of it? I really like the idea.

Reply to
insufferable bore

sounds like a good idea I could not view that website for some reason. :-(

Reply to
One out of many daves

MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.