P0390 OBD-II code — what it means and what to check

ℹ Guidance only — not a substitute for inspection

Enter the trouble codes from your scanner to see what each one means, how urgent it is, and which checks to do first.

← Open the full OBD-II Code Interpreter

Your trouble codes

Enter the codes exactly as your scanner shows them. Separate several codes with spaces or commas.

A letter followed by four characters, for example P0301. Up to ten codes at a time.
Reset

Your codes, interpreted

What this means
⚠ Have this looked at now. At least one code you entered should not be left until the next service.
What to doArrange a workshop inspection now, and keep journeys short and local until then.

Your codes

  1. P0390 — Engine timing (service now). The camshaft position sensor "B" circuit on bank 2 is faulty. The engine may start slowly, run poorly, or not start at all.

Checks to do first, in order

  1. Inspect the sensor connector and wiring on bank 2.
  2. Check for oil contamination at the sensor, which is common when a seal has failed.
  3. Verify timing chain or belt condition if a crankshaft/camshaft correlation code is also stored.

Codes this tool cannot interpret

How this result was reached
  • Interpretations cover standardised codes only, and describe what a code means rather than what is wrong with your specific vehicle.
  • A stored code identifies the circuit or system reporting a fault. It does not identify the failed part — a sensor commonly reports a problem it did not cause.
  • Reviewed by Project Owner on 2026-08-26.
  • This tool covers a reviewed subset of standardised codes. A code it does not recognise is reported as undocumented rather than guessed at.