P0729 OBD-II code — what it means and what to check

ℹ Guidance only — not a substitute for inspection

Enter the trouble codes from your scanner to see what each one means, how urgent it is, and which checks to do first.

← Open the full OBD-II Code Interpreter

Your trouble codes

Enter the codes exactly as your scanner shows them. Separate several codes with spaces or commas.

A letter followed by four characters, for example P0301. Up to ten codes at a time.
Reset

Your codes, interpreted

What this means
⚠ Have this looked at now. At least one code you entered should not be left until the next service.
What to doArrange a workshop inspection now, and keep journeys short and local until then.

Your codes

  1. P0729 — Transmission (service now). The transmission's 6th gear ratio is outside the expected range. The gearbox is not achieving the ratio the computer commanded.

Checks to do first, in order

  1. Check transmission fluid level and condition first — low or burnt fluid causes most ratio faults.
  2. Note when it happens (cold, hot, under load) to describe to the workshop.
  3. Have the transmission scanned for its own stored codes; this code is a symptom, not a diagnosis.

Codes this tool cannot interpret

How this result was reached
  • Interpretations cover standardised codes only, and describe what a code means rather than what is wrong with your specific vehicle.
  • A stored code identifies the circuit or system reporting a fault. It does not identify the failed part — a sensor commonly reports a problem it did not cause.
  • Reviewed by Project Owner on 2026-08-26.
  • This tool covers a reviewed subset of standardised codes. A code it does not recognise is reported as undocumented rather than guessed at.