"check brake" light on - 91 Sub

Last time this light came on, found a leaking slave cylinder on the rear axle. Replaced the slave, flushed the lines with clean fluid, bled the air, and all was well. Braking action is normal. 165K miles without much fuss.

Have checked all 4 wheels, no indication of oil staining, has thick shoes & pads, no scoring. No stains at master cylinder, brake fluid level is normal.

Brake pedal is a little soft but it's been that way for 25k miles. If pedal is held, it slowly goes to the floor (20 seconds) but it brakes well with no pulling, noise or pedal feedback. Am thinking the master cylinder is leaking internally. How do I diagnose that? How difficult / messy for R&R. $200 at a garage? TIA, F

Reply to
fireant
Loading thread data ...

You just did diagnose it, pedal going slowly to the floor. Unplug the wire that goes to the master, if the light goes out, thats the problem.

Reply to
ShoeSaleman

MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.