General Ford Forum

faulty belt determination and replacement?

I have an '03 Taurus wagon 3.0 OHV the is squeaking a lot from the passenger side. I believe it is one of the belts, bu...

4 comments posted 11yrs

posted by johnjohn

4 comments posted 11yrs posted by johnjohn

delayed illumination of light

2012 ford mustang. i do not drive this car daily. one tire has a very slow leak, need to air it up about every month or...

1 comments posted 11yrs

posted by old fart

1 comments posted 11yrs posted by old fart

1999 Mercury Sable problems

Hello! I'm trying to help out a friend with a problem she's having with he r Sable. This started two or three weeks ago...

1 comments posted 11yrs

posted by gerri_daniels

1 comments posted 11yrs posted by gerri_daniels

MIL light on, two new codes on my 2000 Sable Vulcan OHV

Well, less than 6 weeks after my ordeal with the defective pcb valve, the engine light came on yet again today. Upon sc...

17 comments posted 11yrs

posted by saseag44419

17 comments posted 11yrs posted by saseag44419

cheapest scanner that shows live data?

Looking for recommendations for a cheap OBD scanner that not only shows codes, but live data including fuel trims. Graph...

7 comments posted 11yrs

posted by jaysonA7899

7 comments posted 11yrs posted by jaysonA7899

ford explorer ignition replacement

How much should I have to pay for ignition replacement in a 1999 ford explorer?

0 comments posted 11yrs

posted by Kathy

0 comments posted 11yrs posted by Kathy

two 3.0 OHV based cars, one with rough idle

I've been having a time with my 2001 Sable. I recently changed out the plugs/ wires as the car has 125K miles and the p...

6 comments posted 11yrs

posted by none

6 comments posted 11yrs posted by none

busted wiring harness replacing cam synch on my 03 Taurus, how to remedy?

I replaced my cam synch today on my Taurus 03 Vulcan ohv. However, in the process while trying to reach the cam, there...

1 comments posted 11yrs

posted by santos1944

1 comments posted 11yrs posted by santos1944

burning oil smell in vents

2001 mercury sable - for years now, there is a burning oil smell coming through the vents when turning on the vent tryi...

1 comments posted 11yrs

posted by HandymanBob

1 comments posted 11yrs posted by HandymanBob

spark plugs, fuel trims

All of the spark plugs and new wires arrived and I changed the three front plugs/ wires yesterday. Not sure whether or...

19 comments posted 11yrs

posted by saseag44419

19 comments posted 11yrs posted by saseag44419

1990 e 350 ignition key hard to turn

The ignition key feels like it is gummed up and is very hard to turn. R&R or replace?

2 comments posted 11yrs

posted by Greg Carver

2 comments posted 11yrs posted by Greg Carver

intake manifold plenum gasket replaced; pcv valve replaced--- still problems

I think I may need some more help. To catch you up, the vacuum leak was coming from the pcv valve boot on the side agai...

19 comments posted 11yrs

posted by saseag44419

19 comments posted 11yrs posted by saseag44419

intake manifold removal help, Vulcan 3.0 OHV

Previous thread dealt with codes I was getting and smoke test showed smoke coming out from under the area circled in re...

0 comments posted 11yrs

posted by saseag44419

0 comments posted 11yrs posted by saseag44419

PO174 and PO171 codes, 2000 Mercury Sable

My two year inspection is due this month and wouldn't you know that my service light comes on with the two subject code...

45 comments posted 11yrs

posted by saseag44419

45 comments posted 11yrs posted by saseag44419

plow for 1994 F150 4WD with I Beam front suspension

I have a 7-1/2 Ft Fisher MM Plow that would like to install on my 1994 4WD F150 Extendid Cab. Will plow only my driveway...

1 comments posted 11yrs

posted by Tricky Dick

1 comments posted 11yrs posted by Tricky Dick