The alarm system is ten years old and no longer working so I like to remove it as it interferes with the door and hatch locks. The original installer provided no information as to what was done to the car schematically or where the device is hidden. Disconnect the battery and reconnect it will set off the alarm as intended but no longer desired. Where would one start to remove the alarm circuit?
How do you remove an aftermarket keyless alarm?
Apr 26, 2008
1 Replies
Well man you can , first off remove all your lower dash plastics to see what you got. Alarms are normally located by or near your cars interior fuse box is. Try to find anywiring different from all the rest. The alarm wiring will probably be solid colors ,but some alarm manufacturers vary, and your cars wiring will have 2 different colors on the wire. Anyway folow the wires to the main control box. Caution, unplugging it may not jus solve the problem , some alarms are spliced to ignition wires that control power. You will have to find and resolder them together. If this sounds to complicatesd for you don't attempt cause you could cause more bad then any good,so go down to your local stereo shop , tell em what's up and they could do it right and probably for pretty cheap.
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required