1987 Camry Front Suspension Question

I have a couple of questions about the 1987 Camry Front Suspension

The lower control arm ( there is just one control arm per side) bushing. The large busing, the one that the Sway (stabilizer) bar goes through.

Are there one or two pieces per side?

Do these need to be pressed in or do they just seat in.

the reason I am asking is that looking at the pictures of the part online, assuming that I'm looking at the correct part, it seems like the part just has a small lip on it, therefore it doesn't get pressed in.

Also the part lookup listed 4 per car, thinking two per side, one on each side of the hole that the sway bar goes into the lower suspension arm.

Is this correct?

Thanks

Reply to
Tube Audio
Loading thread data ...

Toyota normally uses a one-piece bushing under the sway bar mounting bracket.

It should be very easy to check the bushing, remove the bolt from the bracket, lift the bracket off, and the bushing should be underneath.

The bushing is split, so when you remove the bracket, you can easily remove it.

The part number might be the same for the rear sway bar bushings.

Reply to
Ray O

MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.