I replaced spark plug cables and matched them incorrectly. As I was trying to pull out the cable, the cable came out from crown undamaged, but the crown remained in place. I then fitted cables in appropriate crowns. So far, this has worked fine. Will this work fine in the long run or should I replace the cables?
What is the correct way (with minimum number of steps) to replace gas filter?
Thanks in advance
I would just replace them, as low as $28.89 plus shipping from
NGK makes excellent ignition parts. I'll steer away from Denso plugs and wires. I prefer the NGK Iridium-IX or Laser Iridium plugs. At $34.89 the NGK wire set is a deal. If you want to save a few bucks, go with Bosch. Bosch is a manufacturer and distributor, so you may get a rebox set of NGKs or other makes. I use Bosch planar type oxygen sensor, best in class.
As for gas filter, google. People reported problems with the lower flare nut seizing! So be careful.
== Kroil and crow foot wrench
Have something to add? Share your thoughts — no account required.
Ask the community — no account required