2002 Toyota Tundra 1310 1320 1340 codes

HELP!!! 2002 Tundra V8 2x4 with 149K miles, idles rough than after turning off engine and restarting, it runs fine for awhile than same issue occurs with engine light on. New coils, wires good, new ECU... out of time here and getting desperate enough for the dealer. I need to pinpoint possible issue and solve. Never changed any sensors, belts or pumps.....

Reply to
SylsTundra
Loading thread data ...

Bad cam sensor on at least one bank, almost certainly. 1310 is an igniter circuit failure code. 1320 is a no signal to coil #5, and 1340 is a camshaft sensor code.(bank 1 sensor 2)

A bad camshaft sensor (or connection) could cause all 3 codes.

Reply to
clare

see

formatting link
for testinp prcedure for 1310 code

Reply to
clare

MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.