I'm getting a 00.5 ohm reading on the primary coil. Ohmmeter is set on
Not according to what you posted. That reading is within spec.
Thank You
Are you getting 0.05 or 00.5 (which is properly expressed as 0.5, by the way)? 0.05 is way below the spec you posted, 0.5 is right in there where you want it.
If you have multiple coils, have you tried swapping them around to see if the dead cylinder follows the coil?
Re read your first post. I think you made an error in the placement of the decimal point, the error affects whether or not the coil is within spec.
My problem was the timming belt.
Jeff Strickland wrote:
Have something to add? Share your thoughts — no account required.
Ask the community — no account required