I have been running the Meter Tests on the oxygen sensor on a 81 1.7L FI rabbit, and the Bentley Manual at page 74 of section 4, says that after the engine is started, and runs for a few minutes, that the dwell meter reading should fluctuate. My question is how much fluctuation is supposed to occur. When I ran the test at about 1500 rpm the dwell meter moves around the 45 degree mark, but only plus or minus 3 or 4 degrees, when the engine speed is increased to say 3000rpm, the dwell reading increases but still there is not much fluctuation. How much fluctuation is supposed to occur. All the other tests checked out. The oxygen sensor has less than 6000 miles on it.
81 rabbit--Oxygen sensor Test
Sep 11, 2006
3 Replies
at idle introduce a vacuum leak, or inject some carb cleaner into a vacuum hose, and watch your dwell meter. ;-) sounds like it is online and functioning.
shot the carb cleaner into the disconnected vacuum hose, and the engine stumbles, the idle dropped, and the dwell meter fell to 22-25 degrees which is i assume the control unit and frequency valve making a lean correction for a rich mixture --- right or wrong????? after thestumble and the burning of the carb cleaner, and the idle stabelizing the dwell came back to 45 degrees and moved up and down 3-4 degrees from 45.
jfrinuniontown
sounds like things seem to be working. ;-)
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required