Chevrolet 4x4 Trucks

  1. Home
  2. Chevrolet 4x4 Trucks
8576 Threads Posts
to

Worth reading in Chevrolet 4x4 Trucks

90 S10 Speedometer

I replaced the speed senor on the transmission and this did not fix the speedometer. What should I check next?
5 comments posted 22yrs
posted by diam052254
5 comments posted 22yrs posted by diam052254

Re: Is GMC Gremlin insane?

Just spammin it on over to the other NG as always... forgot to originally.... GMC Gremlin > 1970's GM 3/4 ton long bed...
21 comments posted 22yrs
posted by death
21 comments posted 22yrs posted by death

Loose ball joint

OK, here's another 1997 Chevy Blazer question for ya. Just got done putting some new rubber on and was going to get it...
3 comments posted 22yrs
posted by jelbert
3 comments posted 22yrs posted by jelbert

how to vacuum test a 1997 5.7L engine?

I'd like to hook up a vacuum gauge to the intake manifold of a 1997 chevy 3/4 ton 4-wheel drive pickup with a 5.7 L eng...
1 comments posted 22yrs
posted by wind
1 comments posted 22yrs posted by wind

WTB aluminum Heads for a SBC

please send pic, price and spec, thanks Garrison
0 comments posted 22yrs
posted by garrisonf
0 comments posted 22yrs posted by garrisonf

Headers on a 1994 GMC K1500

I'm debating on putting headers on my 1994 GMC K1500, 350 w/TBI. Right now, all is stock. Right now, I have a crossover...
6 comments posted 22yrs
posted by andyw00
6 comments posted 22yrs posted by andyw00

$1.69 gal. GAS during August

. . Regular Unleaded Pensacola Good times is a come'n fer shure. Florida has a waiver on the State Fuel Tax the rest of...
0 comments posted 22yrs
posted by SwampGrassProductionsStudio
0 comments posted 22yrs posted by SwampGrassProductionsStudio

How do I remove the drums on a 97 GMC Jimmy?

Its time to change the brakes pads on my 97 Jimmy. I figure I'll give it a try and save a few bucks. It looks as if a s...
6 comments posted 22yrs
posted by NotToday
6 comments posted 22yrs posted by NotToday

95 heater vacuum h2o valve flakey

In my 1995 Tahoe the vacuum valve that controls hot water to the heater core is acting weird. It wasn't working (mostly...
0 comments posted 22yrs
posted by booterchevski
0 comments posted 22yrs posted by booterchevski

Could a bad front wheel bearing/hub cause a clunk?

Lil Jimmy is still clunking away somewhere in the front end, likely the left front (long story, been beaten to death ma...
4 comments posted 22yrs
posted by trypticon
4 comments posted 22yrs posted by trypticon

K&N FIPK Question

Grettings, I have a 1997 Blazer 4.3. I have been considering installing a K&N FIPK (Fuel Injection Perfromance Kit). An...
6 comments posted 22yrs
posted by jelbert
6 comments posted 22yrs posted by jelbert

Rust problem

My father has a 1994 z71 with about 70k on it. It seems to have a serious rust problem. So far the bumper has rusted th...
4 comments posted 22yrs
posted by wheelnchef
4 comments posted 22yrs posted by wheelnchef

Purchasing a DANA 60 rear axle.

Dearest Group, I am considering purchasing a DANA 60 rear axle from a private party. I have not seen the axle yet, it i...
8 comments posted 22yrs
posted by death
8 comments posted 22yrs posted by death