BMW Cars and SUVs

  1. Home
  2. BMW Cars and SUVs
6401 Threads Posts
to

Worth reading in BMW Cars and SUVs

Re: What type of car do you drive, a white one?

Just curious. Why is tripe being discussed on a BMW site? Do all BMW owners eat this food? Does a free sample come with...
0 comments posted 19yrs
posted by tw1985fla
0 comments posted 19yrs posted by tw1985fla

BMW Cars to Accept Credit Cards

http://www.ng2000.com/news.php?tp=bmw At the CARTES electronic expo at Paris, BMW and Visa have teamed up to develop a...
0 comments posted 19yrs
posted by schmoozes
0 comments posted 19yrs posted by schmoozes

heater resister

i have a 91 525i heater blower motor only works on high speed. i have replaced the motor because it was bad but still o...
6 comments posted 19yrs
posted by kalley5
6 comments posted 19yrs posted by kalley5

Keeping Convertables unlocked

I am going to have an alarm put into my Z4. I asked the owner what would prevent someone from cutting through the top,...
9 comments posted 19yrs
posted by seagle
9 comments posted 19yrs posted by seagle

Oil Pan for '84 733 series

Can someone steer me in the right direction. I keep my eyes on the junk yards but no luck so far. From the dealership it...
0 comments posted 19yrs
posted by CELDT
0 comments posted 19yrs posted by CELDT

1987 325e Heat not working

Hello, I have a a 1987 black 325e and the cabin heat is not working. What would you recommend? (no heat at all).
2 comments posted 19yrs
posted by jason.carvalho
2 comments posted 19yrs posted by jason.carvalho

Alternator mount bushing 84 733i

The upper bolt on my alternator is cocked because the bushing is shot. That means the alternator sits crooked, and the...
2 comments posted 19yrs
posted by cmciver
2 comments posted 19yrs posted by cmciver

Poor E39 handbrake.

Have any E39's got good h/brakes? Auto 528i Had new rear discs, pads, and shoes fitted today. Handbrake is still very p...
19 comments posted 19yrs
posted by metier
19 comments posted 19yrs posted by metier

'98 M3 rotors - can/should they be re-machined?

feeling vibration in my '98 M3 during braking. Can / should I have the rotors machined to remove run out? Or just replac...
36 comments posted 19yrs
posted by derek_mcquarrie
36 comments posted 19yrs posted by derek_mcquarrie

Dial gauge for brakes

I'm planning to service the brakes on my '98 M3. I'd like to get a good quality dial gauge to check rotor run out, and...
8 comments posted 19yrs
posted by derek_mcquarrie
8 comments posted 19yrs posted by derek_mcquarrie

handbrake cable replacement on 7351/1985/

HAS ANY ONE DONE THIS. CAN IT BE DONE ENTIRELY UNDER THE CAR WITHOUT LIFTING OF THE HB CONSOLE INSIDE THE CAR/ TO FIT TH...
0 comments posted 19yrs
posted by openvu
0 comments posted 19yrs posted by openvu

Low coolant

My low coolant light has been coming on at first start in the morning. It only stays on for a short while (about a quar...
5 comments posted 19yrs
posted by joetide
5 comments posted 19yrs posted by joetide

2000 523 Auto - Stall or running rough when WARM

My 523 occasionally stalls immediately after starting, or runs with reduced power and threatens to stall when stationar...
0 comments posted 19yrs
posted by john.graves
0 comments posted 19yrs posted by john.graves

330 aux belt - tool

Hiya I want to change the 2 engine auxilliary belts. It looks like i need to remove/loosen the tensioners but I dont se...
0 comments posted 19yrs
posted by dont
0 comments posted 19yrs posted by dont