Recently did a brake job on my 96 XLT 4x4. When I took the rotor off the rear right assembly, it was real difficult like the e-brake shoes were expanded in the drum, but the e-brake was off. I looked behing the hub and noticed the cable was OFF the actuating lever, (which explains why my e-brake pedal goes to the floor from so much slack)
I was able to pull the actuating lever OUT of the dust boot from the backing plate. No clip or anything was keeping it in. On the other side, I couldn't do this, it was firmly in place. I put the cable back on the lever, but inside the e-brake drum assembly the lever would not stay in place and I couldn't find where it would be clipped or snapped into place.
I am looking for my Chiltons now, but they show a lot of pre-1995 models in their examples (unless the brake assemblies are the same)
Any help would be greatly appreciated on how this e-brake lever stays in place.
Thanks!