General Ford Forum

  1. Home
  2. General Ford Forum
14525 Threads Posts
to

Worth reading in General Ford Forum

bad ford escort alarm

Problem - my girlfriend's car alarm started going haywire. Now the car won't start. I'd have AAA tow it to a Ford place...
0 comments posted 20yrs
posted by louloizides
0 comments posted 20yrs posted by louloizides

PA gas good, NY gas bad

What is the difference between PA and NY's gasoline additives? In my '98 Escort SW, Gas bought in PA -> 35.0mpg, $3.029...
22 comments posted 20yrs
posted by zwsdotcom
22 comments posted 20yrs posted by zwsdotcom

1992 Ford Taurus overheats, is the fan the issue?

About a month ago I bought a '92 3.0L Taurus that has been overheating and I've noticed that when I turn on the AC, the...
2 comments posted 20yrs
posted by seyeRMReyes
2 comments posted 20yrs posted by seyeRMReyes

1999 Mercury Sable

Could someone tell me exactly where the vehicle speed sensor is located on a 1999 Mercury Sable 3.0L? Is it accessible f...
1 comments posted 20yrs
posted by mamagistri
1 comments posted 20yrs posted by mamagistri

Problem with rear brake light bulb replacement

Hello, I know that this may sounds simple but it's not. I had a friend look at it also and he couldn't figure it out. I...
2 comments posted 20yrs
posted by hoops_nospam444
2 comments posted 20yrs posted by hoops_nospam444

98 contour timing belt

I replace my water pump and timing belt. After about a month the timing belt was shreaded. I replaced the belt and the...
1 comments posted 20yrs
posted by bluefalcon4
1 comments posted 20yrs posted by bluefalcon4

1995 Ford E350 RV 460 Pre-detonation Problem

The truck has 15000 miles on it and has been thru 3 engines due to pre-detonation. Timing is correct but jumps around a...
0 comments posted 20yrs
posted by dabworth
0 comments posted 20yrs posted by dabworth

2001 Expedition Door Keypad Code

I have a 2001 Expedition with the keypad on the drivers door. I have the factory code and it works fine. I've read post...
1 comments posted 20yrs
posted by notgq
1 comments posted 20yrs posted by notgq

c4 identification troubles

I have a 66 mustang with a 289 and a c4. I'm getting ready to rebuild the c4 but I'm getting alittle confused with the...
4 comments posted 20yrs
posted by hill021
4 comments posted 20yrs posted by hill021

brake calipers and missing bolts

I have a 97 Ford Ranger and, a few years ago, replaced the fromt brakes (including new rotors). As I had not done it be...
0 comments posted 20yrs
posted by smhughes
0 comments posted 20yrs posted by smhughes

97 Taurus SHO RL brake overheating

Hi All! Last summer my RL brakes overheated so much that the pads melted to the disc. I took it into meineke (not happy...
8 comments posted 20yrs
posted by none
8 comments posted 20yrs posted by none

tapping noise after shut-down in rebuilt 302

There is a distinct tapping sound coming form the intake manifold(new Edelbroch 289 Performer). This sound will occur e...
4 comments posted 20yrs
posted by stargazer14
4 comments posted 20yrs posted by stargazer14

93 5.0L Mustang.. no spark

yesterday I started to drive my Mustang, the engine was running and acting normal. Then it was just like I turned off t...
8 comments posted 20yrs
posted by ArcheryHunter
8 comments posted 20yrs posted by ArcheryHunter

96 Taurus Tension Pulley

I replaced my belt due to the old one being loose and causing the alternator light to come on at high speeds. Once I re...
9 comments posted 20yrs
posted by jdag68
9 comments posted 20yrs posted by jdag68