Autodata says:
inlet 0.23 -0.27 mm hot ex. 0.25 - 0.29 mm hot
I don't know the brakes offhand, but usually you remove the hub nut and then the drum and hub will come off. the nut is retightened to 80 -120 nm
mrcheerful
Autodata says:
inlet 0.23 -0.27 mm hot ex. 0.25 - 0.29 mm hot
I don't know the brakes offhand, but usually you remove the hub nut and then the drum and hub will come off. the nut is retightened to 80 -120 nm
mrcheerful
Anybody know if there's an equivalent to the American "Alldata"? A sort of online resource where you can find specs and maintenance data, for example, valve clearances for my girlfriends Suzuki Alto. Haynes don't make a manual, Suzuki say they cannot supply them for older models (it's a year
Also, quite a basic question this, how do I check the rear brake shoes on it? I cannot remove the brake drum. There's nothing holding it on at the front. There are 2 rubber grommets at the back, but I've tried fiddling about in there. And yes the handbrake was off.
Cheers,
Carl.
Have something to add? Share your thoughts — no account required.
Ask the community — no account required