I had the climate evaporator changed so the dashboard was totally removed....
since this big work, I had several small bugs repaired and fixed; but still 2
bugs are present:
1) The outside temperature is wrongly displayed: When I start the car the
external temperature looks good but after 10 seconds
approximately (or less) the values goes down for 10° celsius: For example from
24 to 14.
The gauge (under the license plate) is well working: I Unplug the electric
connector of the gauge located in the general fuse box
and I plug here a 9000 Ohms resistor and the temprature indicate +1°C and after
a while - 7°C(in less than 10 seconds).
This is very odd ??? Any ideas ?
2) The inside temperature adjustement knobs are crossed: When I adjust the left
one the temperature changed at the right side and
vice versa ... The garage mechanic told me that this cannot be a connector as
there is only one for this part on the dash board ???
and no mistake can be done ... true or not ?? Any ideas ?
PS: The reply address is not valid. Thanks to reply to
firstname.lastname@example.org but remove 1234 in my email adress or
directly in the forum..