I have a '69 Mustang that I recently had to replace the driver side floorpan. With the uni-body design, it occured to me that some flex probably occured when the old pan was cut out. If I weld in subframe connectors and the frame is not perfectly square, will I be doing more harm than good?
Any frame ailignment prep required before installing subframe connectors?
Jul 20, 2006
1 Replies
First reply
no, just adding more metal, make it all stiffer. But do it up on a lift where the the lift hold the wheels only If not you will get flex putinto the mess.
Read the full reply
no, just adding more metal, make it all stiffer. But do it up on a lift where the the lift hold the wheels only If not you will get flex putinto the mess.
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required