Hi please could somebody please advise how i can change the wiper balde on the driver side i try to raise the arm it is sitting on but it is sitting under the bonnett i i have tried lifting to half a cycle but it will not raise any higher than half an inch please help thanks
Nige
Erm, pop the bonnet and try whilst it's up? You have to do that with most cars these days aas the wipers are usually tucked away below the back edge of the bonnet.
Chris
I did mine a few weeks ago. I did not need to raise the bonnet or anything. With the clip undone there was enough clearance to slide the unit off. I ran the wipers and switched off the ignition when the blade was at the top of its stroke. Then you lift the lever where the blade fits on the arm and slide the blade unit down the arm and out of the hooked end on the arm. There is sufficient space in the blade frame to do this without having to lift it very far away from the screen.
Have something to add? Share your thoughts — no account required.
Ask the community — no account required