Hey all I keep cooking ignition control modules on my 91 GA 2.3 quad 4. It will run for a while and then die. Any ideas where to start looking for the problems? Steve
Ingnition Control Modules 2.3 Quad 4
Jul 01, 2003
5 Replies
Unfortunately, there is no good way to check the coils. They / one may be breaking down at high temp and high voltage. YOu could try measuring the ohms... 1 to 9 ohms and 5k ohms, iirc but that won't tell you much.
Sounds like the ign.mod could be bad or the wires to it are bad somewhere. A bad coil will blow the ign.mod in no time at tall. This is a tough one to diagnose from a distance. Paul.
Hey I finally got it to run and its been idling for the better part of an hour now. I got mad at the wire harness and ripped out the POS wire of the IGN module. I found a chaffed spot on the wire where bare copper was exposed. Its now running in the garage(door open). This only cost me about
gounded..............................
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required