I have a 1999 SC1. I have definitely determined that I need to replace my horn and have purchased one. I see that the horn is located just behind and a bit below the drivers side headlamp but am not sure of the best procedure for accessing and swapping out the horn.
Should I work on this from below, above? What should I removed to access it?
Thanks for the advice.
replace my horn
procedure for
I installed a set of Fiamm horns on my SL2. I removed the left front tire and inner fender. Decent amount of room to access the horn.
Ken
Just did this the other day on my 98 SC1. Not a bad procedure. Remove three bolts (7mm if I remember correctly) each from drivers and passengers fender, two bolts each in front of each tire under the bumper. Take all three plastic pop-clips out, under the hood in front of the hood release. Pull the bumper forward about three inches, and then the bumper will drop, and you can easily access the horn.
Not positive if the 99 is exactly the same as the 98, but should be similar anyway.
Hope this helps!
THANK YOU VERY MUCH!
No problem. That's why we're here.
Ken
MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.