95 Legecy, water pump/thermostat

Jun 12, 2004 1 Replies

I just replaced the front seals and waterpump. It acts like the water pump is not turning. I get no blowing hot air inside the car. I put in a new thermostat, then tried the old one. Same problem with both. If I remove the bleeder screw from the radiator just steam comes out. All worked fine before. Temp gauge goes to hot position.


1995 Legecy wagon
2.2 auto
109000 miles

new crank seal, new cam seals, new water pump



TIA Tim


probably need to replace the rad cap, purge air outta the system (elevate fron end on curb/ramps whatever, select heat inside/ fill o'flow with coolant, run till fans come on, allow to cool, monitor o'flow for several drive cycles) OR you have a bad headgasket.

Carl

1 Lucky Texan

p51mustang wrote:

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required