Spark plug connector pulled...oil dribbles out

If you're lucky, it means the gasket on the bottom of the spark plug wasn't quite seated correctly, or some oil spilled on it while you were adding/changing oil.

If you're not lucky, it means the rings are going and a rebuild might soon be in order.

On Nov 1, 9:45 pm, Hachiroku $B%O%A%m%/(B wrote: > If you're lucky, it means the gasket on the bottom of the spark plug

Let me clarify: the oil didn't come up from where the spark plug sits at the bottom of its well. That is, it didn't leak from around the spark plug gasket. It came from _above_ the spark plug, at the top of its well where it meets with the piece of metal that is bolted in place over the cylinders. (It's called the valve cover, I think.)

-- Charles Packer

You need to replace the valve cover gaskets. The seal around the spark plug well is leaking. This is not that big a deal and the parts aren't that expensive. It's a driveway DIY if you have the tools and mechanical ability, otherwise it's couple of hours labor at a shop.

I had oil discovered in spark plug wells and was told I needed a new valve cover gasket to correct it.

Then again, this particular mechanic turned out to be less than honest, so take this with a grain of salt.

-- Todd H.

OK! See Mulder's comment.

I did this only on an '88 Supra, and that was a chore only because the intake (air) runs over the top of the valve covers...you have to remove all the air passages to get to them.

This should be a piece of cake.

I replaced my spark plugs and found oil in the same place a long time ago. It might have been at 100k kms or 150k kms. I have a 2003 OBS. I never did anything about it, and the next time I replaced the plugs, no oil.

I'm due for another spark plug change so I'll post my results.

Chicobiker

I'm tempted to do as you did and just replace the plugs. It just occurred to me -- duh -- that I can at least pull the plug connectors of all four plugs far enough out to inspect the situation without removing all that other harware that you have to remove to do a complete plug job.

At any rate, somebody sent me this page that has well-photographed instructions for the job:

-- Charles Packer