turbo manifold

Hi i got a 1994 Toyota Camry 2.2 i4 5spd and i would like to know where i can get a turbo exhaust manifold that fits the 2200 Camry motor. i got a Garrett t25 turbo for it.

i think the exhaust manifold from a 91-95 Mr2 turbo would fit the Camry is this right?

and do you guys think i can run 5-6 psi on the 2200 motor or not?

Reply to
es
Loading thread data ...

Opinion:

The way I've seen cars turboed is by the fitting of a suitable shaped length of exhaust pipe to connect the manifold to the turbo,..then another piece is bent-up to connect the turbo exhaust output back down to the Cat-convertor. This is an easy job for an exhaust place once you've decided where to position the turbo,..how big its input and output diameters are, etc etc.

The way I would approach it is to have a look at the Burien Turbo mod to the

5SFE or 2.2L motor Camry. Theres a bit of BS around about the 2.2 not being able to handle high outputs due "thin blocks" which is a critisism of the block's strength under high power. As power level rise the block has to *hold everything together*. As another example of this type of comment, the last Ford 351Clevelands were accused of being thin castings which allowed bore misalignment after heavy use. How true these claims are could be sussed out by having a 5SFE block sonic tested, but I wouldn't be afraid to give one 5-6 psi straight up. Anything higher, like 10-14psi is something I'de avoid as the engine was not designed to be a turbo-donk.

Jason

Jason

Reply to
Jason James

MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.