In replacing the rear disk rotors on this 98 VR6, I notice that the originals have a "gear like" arrangement on the back which I suspect interacts with a magnetic sensor on the mounting bracket. The replacement rotor is smooth rather than having these teeth. Is it OK to use this replacement or will I have problems with these rotors?
Any advice welcome. David Abineri
If it is like my '96, the "gear like" thing is a steel basket with [I think I counted] 43 little bars. This will pry off of the old rotor without a lot of force. The Bentley book recommended using a drift to tap it out. I did well by prying a little at a time.
Clean and reuse.
Of course your wheels may be different from mine.
Thanks Tom, that's exactly what I did. Prying it loose and installing on the new one works great! I appreciate your saving me all sorts of time finding out about this.
David Abineri
Tom's VR6 wrote:
MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.