Rats, My wife's Town and Country had a 'dead' headlight - drivers side. I figured it would be no big deal to put in a new one. Which was easy. Unfortunately, when I took the old one out, it seemed to be "okay", the filament was intact and the glass wasn't darkened. So I put in a new one, and tested to see if it came on. NOPE! I tried to see if the 'wires' were missing any insulation, but there is only about three or four inches of 'loose' wire before it goes into a wire bundle that is wrapped with heavy plastic, and I couldn't tell (easily) how far down towards the left front tire it went. The wire bundle is pretty "tight" and inflexible at that point, just below and behind the light element replacement.
Does anyone have any similar experience with this kind of probably wiring anomaly on a 2000 Chrysler Town and Country??
Thanks in advance for any info!